Group velocity

New waves seem to emerge at the back of a wave group, grow in amplitude until they are at the center of the group, and vanish at the wave group front.
For surface gravity waves, the water particle velocities are much smaller than the phase velocity, in most cases.
The group velocity of a wave is the velocity with which the overall shape of the waves' amplitudes—known as the modulation or envelope of the wave—propagates through space.
For example, if a stone is thrown into the middle of a very still pond, a circular pattern of waves with a quiescent center appears in the water. The expanding ring of waves is the wave group, within which one can discern individual wavelets of differing wavelengths traveling at different speeds. The longer waves travel faster than the group as a whole, but their amplitudes diminish as they approach the leading edge. The shorter waves travel more slowly, and their amplitudes diminish as they emerge from the trailing boundary of the group.
Contents
Definition and interpretation
Definition

The group velocity vg is defined by the equation:[2][3][4][5]
where ω is the wave's angular frequency (usually expressed in radians per second), and k is the angular wavenumber (usually expressed in radians per meter).
The function ω(k), which gives ω as a function of k, is known as the dispersion relation.
- If ω is directly proportional to k, then the group velocity is exactly equal to the phase velocity. A wave of any shape will travel undistorted at this velocity.
- If ω is a linear function of k, but not directly proportional (ω=ak+b), then the group velocity and phase velocity are different. The envelope of a wave packet (see figure on right) will travel at the group velocity, while the individual peaks and troughs within the envelope will move at the phase velocity.
- If ω is not a linear function of k, the envelope of a wave packet will become distorted as it travels. This distortion is directly related to group velocity, as follows. Since a wave packet contains a range of different frequencies, the group velocity ∂ω/∂k is a range of different values (because ω is not a linear function of k). Therefore, the envelope does not move at a single velocity, but a range of different velocities, so the envelope gets distorted. See further discussion below.
Derivation
One derivation of the formula for group velocity is as follows.[6][7]
Consider a wave packet as a function of position x and time t: α(x,t). Let A(k) be its Fourier transform at time t=0:
By the superposition principle, the wavepacket at any time t is:
where ω is implicitly a function of k. We assume that the wave packet α is almost monochromatic, so that A(k) is sharply peaked around a central wavenumber k0. Then, linearization gives:
where and
(see next section for discussion of this step). Then, after some algebra,
There are two factors in this expression. The first factor, , describes a perfect monochromatic wave with wavevector
, with peaks and troughs moving at the phase velocity
within the envelope of the wavepacket. The other factor,
, gives the envelope of the wavepacket. This envelope function depends on position and time only through the combination
. Therefore, the envelope of the wavepacket travels at velocity
. This explains the group velocity formula.
Higher-order terms in dispersion
Part of the previous derivation is the assumption:
If the wavepacket has a relatively large frequency spread, or if the dispersion has sharp variations (such as due to a resonance), or if the packet travels over very long distances, this assumption is not valid, and higher-order terms in the Taylor expansion become important. As a result, the envelope of the wave packet not only moves, but also distorts, in a manner that can be described by the material's group velocity dispersion. Loosely speaking, different frequency-components of the wavepacket travel at different speeds, with the faster components moving towards the front of the wavepacket and the slower moving towards the back. Eventually, the wave packet gets stretched out. This is an important effect in the propagation of signals through optical fibers and in the design of high-power, short-pulse lasers.
History
The idea of a group velocity distinct from a wave's phase velocity was first proposed by W.R. Hamilton in 1839, and the first full treatment was by Rayleigh in his "Theory of Sound" in 1877.[8]
Other expressions
For light, the refractive index n, vacuum wavelength λ0, and wavelength in the medium λ, are related by
with vp = ω/k the phase velocity.
The group velocity, therefore, can be calculated by any of the following formulas:
In three dimensions
<templatestyles src="Module:Hatnote/styles.css"></templatestyles>
For waves traveling through three dimensions, such as light waves, sound waves, and matter waves, the formulas for phase and group velocity are generalized in a straightforward way:[9]
- One dimension:
- Three dimensions:
where means the gradient of the angular frequency
as a function of the wave vector
, and
is the unit vector in direction k.
If the waves are propagating through an anisotropic (i.e., not rotationally symmetric) medium, for example a crystal, then the phase velocity vector and group velocity vector may point in different directions.
In lossy or gainful media
The group velocity is often thought of as the velocity at which energy or information is conveyed along a wave. In most cases this is accurate, and the group velocity can be thought of as the signal velocity of the waveform. However, if the wave is travelling through an absorptive or gainful medium, this does not always hold. In these cases the group velocity may not be a well-defined quantity, or may not be a meaningful quantity.
In his text “Wave Propagation in Periodic Structures”,[10] Brillouin argued that in a dissipative medium the group velocity ceases to have a clear physical meaning. An example concerning the transmission of electromagnetic waves through an atomic gas is given by Loudon.[11] Another example is mechanical waves in the solar photosphere: The waves are damped (by radiative heat flow from the peaks to the troughs), and related to that, the energy velocity is often substantially lower than the waves' group velocity.[12]
Despite this ambiguity, a common way to extend the concept of group velocity to complex media is to consider spatially damped plane wave solutions inside the medium, which are characterized by a complex-valued wavevector. Then, the imaginary part of the wavevector is arbitrarily discarded and the usual formula for group velocity is applied to the real part of wavevector, i.e.:
Or, equivalently, in terms of the real part of complex refractive index one has[13]
It can be shown that this generalization of group velocity continues to be related to the apparent speed of the peak of a wavepacket.[citation needed] The above definition is not universal, however: alternatively one may consider the time damping of standing waves (real , complex
), or, allow group velocity to be a complex-valued quantity.[14][15] Different considerations yield distinct velocities, yet all definitions agree for the case of a lossless, gainless medium.
The above generalization of group velocity for complex media can behave strangely, and the example of anomalous dispersion serves as a good illustration. At the edges of a region of anomalous dispersion, becomes infinite (surpassing even the speed of light in vacuum), and
may easily become negative (its sign opposes
) inside the band of anomalous dispersion.[16][17][18]
Superluminal group velocities
Since the 1980s, various experiments have verified that it is possible for the group velocity (as defined above) of laser light pulses sent through lossy materials, or gainful materials, to significantly exceed the speed of light in vacuum c. The peaks of wavepackets were also seen to move faster than c. In all these cases, however, there is no possibility that signals could be carried faster than the speed of light in vacuum, since the high value of does not help to speed up the true motion of the sharp wavefront that would occur at the start of any real signal.[13][19][16][20][17]
See also
- Wave propagation
- Dispersion (optics) for a full discussion of wave velocities
- Phase velocity
- Front velocity
- Group delay -- "The group velocity of light in a medium is the inverse of the group delay per unit length."[21]
- Phase delay
- Signal velocity
- Slow light
- Wave propagation speed
- Defining equation (physics)
- Matter wave#Group velocity
- Soliton
References
Notes
<templatestyles src="Reflist/styles.css" />
Cite error: Invalid <references>
tag; parameter "group" is allowed only.
<references />
, or <references group="..." />
Further reading
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
- Lua error in package.lua at line 80: module 'strict' not found.
External links
- Greg Egan has an excellent Java applet on his web site that illustrates the apparent difference in group velocity from phase velocity.
- Maarten Ambaum has a webpage with movie demonstrating the importance of group velocity to downstream development of weather systems.
- Phase vs. Group Velocity – Various Phase- and Group-velocity relations (animation)
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lighthill (1965)
- ↑ Hayes (1973)
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Atmospheric and oceanic fluid dynamics: fundamentals and large-scale circulation, by Geoffrey K. Vallis, p239
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ 13.0 13.1 Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ 16.0 16.1 Lua error in package.lua at line 80: module 'strict' not found.
- ↑ 17.0 17.1 Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ https://www.rp-photonics.com/group_delay.html