South African Class 16DA 4-6-2 1928

This article is about one of two different South African locomotive types to be designated "Class 16DA". For the other SAR Class 16DA locomotive, see South African Class 16DA 4-6-2 1930.

South African Class 16DA 4-6-2 1928

300px Baldwin-built no. 850 at Theunissen, 29 May 2005

Type and origin ♠ With 60 inch (1,524 mm) coupled wheels ♥ With 63 inch (1,600 mm) coupled wheels ♣ 22x26 Cylinders - ♦ 23x26 Cylinders Power type Steam Designer South African Railways (Col F.R. Collins DSO) Builder Hohenzollern Locomotive Works Baldwin Locomotive Works Serial number Hohenzollern 4653-4658 Baldwin 60820-60827 Model Class 16DA Build date 1928-1929 Total produced 14

Specifications Configuration 4-6-2 (Pacific) Driver axle 2nd coupled axle Gauge 3 ft 6 in (1,067 mm) Cape gauge Leading dia 30 in (762 mm) Coupled dia ♠ 60 in (1,524 mm) ♥ 63 in (1,600 mm) Trailing dia 33 in (838 mm) Tender wheels 34 in (864 mm) Wheelbase  • Engine 30 ft 8 in (9,347 mm)  • Leading 6 ft 10 in (2,083 mm)  • Coupled 11 ft (3,353 mm)  • Tender 20 ft 5 in (6,223 mm)  • Tender bogie 6 ft 2 in (1,880 mm) Length:  • Over couplers Height ♠ 12 ft 10 in (3,912 mm) ♥ Frame type Bar Axle load ♠ ♥  • Leading ♠♥  • 1st coupled ♥  • 2nd coupled ♥  • 3rd coupled ♥  • Trailing ♠♥  • Tender bogie Bogie 1: Bogie 2:  • Tender axle Adhesive weight ♠ ♥ Loco weight ♠ ♥ Tender weight Loco & tender weight ♠ ♥ Tender type KT (2-axle bogies) Fuel type Coal Fuel capacity 14 LT (14.2 t) Water cap Boiler:  • Pitch ♠ 8 ft 6 in (2,591 mm) ♥  • Diameter  • Tube plates  • Small tubes 181: 2 in (51 mm)  • large tubes 30:  • Firebox type Round-top Boiler pressure ♠ 195 psi (1,344 kPa) ♥ 205 psi (1,413 kPa) Safety valve Pop Firegrate area 45 sq ft (4.2 m2) Heating surface 2,639 sq ft (245.2 m2)  • Tubes 2,453 sq ft (227.9 m2)  • Firebox 164 sq ft (15.2 m2) Superheater:  • Heating area 593 sq ft (55.1 m2) Cylinders Two Cylinder size ♣ 22 in (559 mm) bore ♦ 23 in (584 mm) bore ♣♦ 26 in (660 mm) stroke Valve gear Walschaerts Valve type Piston Couplers AAR knuckle

Performance figures Tractive effort ♠♣ 30,670 lbf (136.4 kN) @ 75% ♠♦ 33,530 lbf (149.1 kN) @ 75% ♥♣ 30,710 lbf (136.6 kN) @ 75% ♥♦ 33,570 lbf (149.3 kN) @ 75%

Career Operators South African Railways Class Class 16DA Number in class 14 Numbers 843-850 & 868-873 Delivered 1928-1929 First run 1928 Withdrawn 1973

The South African Railways Class 16DA 4-6-2 of 1928 was a steam locomotive.

In 1928, the South African Railways placed six Class 16DA steam locomotives with a 4-6-2 Pacific type wheel arrangement in passenger train service. Eight more entered service in 1929.

Manufacturers

Further orders for locomotives similar to the Class 16D Pacific type locomotive were placed for the South African Railways (SAR) in 1928. The design of the earlier engines was modified by the Chief Mechanical Engineer (CME), Colonel F.R. Collins, along the same lines as his design of the Class 15CA Mountain type.

File:Col F.R. Collins DSO.jpg

Col F.R. Collins DSO

This consisted of a locomotive bar frame which was shorter to end at the front of the firebox, with a bridle casting to create a widened frame extension below the firebox and the cab to the rear dragbox, to gain more ashpan room under the firebox.

These redesigned locomotives were designated Class 16DA and were built by two manufacturers in 1928 and 1929. The first six, numbered in the range from 868 to 873, were built in Germany by Hohenzollern Locomotive Works and entered service in 1928. Another eight locomotives, numbered in the range from 843 to 850, were built in the United States of America by Baldwin Locomotive Works and entered service in 1929.

Characteristics

The Hohenzollern and Baldwin-built Class 16DA locomotives basically differed from the predecessor Class 16D only by virtue of its shortened frame and bridle casting, the Class 16D having had a frame extending all the way from the front buffer beam to the rear dragbox. They used the same Type KT tenders with a coal capacity of 14 long tons (14.2 tonnes) and a water capacity of . As delivered, they had 60 inches (1,524 millimetres) diameter coupled wheels and their cylinders were of 22 inches (559 millimetres) bore and 26 inches (660 millimetres) stroke. Their boiler operating pressure was set at 195 pounds per square inch (1,344 kilopascals).

Modification

During the 1940s, six of these locomotives, three from each manufacturer group, were retyred with 63 inches (1,600 millimetres) diameter tyres on their coupled wheels. To not have their tractive effort reduced by the larger coupled wheels, their cylinders were reamed from a 22 to 23 inches (559 to 584 millimetres) bore and their operating boiler pressure was raised to . All the modified locomotives remained classified as Class 16DA.

When the larger tyres were fitted, the old tyres were left in position and turned down on the wheel centres to serve as liners, and the new tyres were then shrunk on over the liners. The practice of increasing the diameter of coupled wheels, wheel spacing and other considerations permitting, was begun by A.G. Watson during his term in office as CME and was continued by his successors. The reduction of tractive effort caused by the larger wheels, was made up by increasing boiler pressures or by fitting larger cylinders or both, as required. This policy resulted in more mileage between heavy repairs, less cost-per-mile on repairs and locomotives capable of higher speeds.

Service

The Class 16DA Pacifics were initially placed in passenger service between Johannesburg and Kimberley, where they regularly worked trains like the Union Express, which became the Blue Train after the Second World War, and the Union Limited.

File:Class 16DA 849 (4-6-2) ID.JPG

x100px

In 1939-1940, when new air-conditioned rolling stock was placed in service on the Union Limited and Union Express services between Cape Town and Johannesburg, all the Class 16DA and Class 16E locomotives were transferred to Bloemfontein in the Free State. From here, they continued to work passenger trains north and south, including the Orange Express, until the Class 15F replaced them and they were relegated to suburban and local passenger train work. They were withdrawn from service in 1973.

Four of the Baldwin-built locomotives were sold into industrial service. No. 844 went to Hlobane Colliery in Natal and later to Umgala Colliery. Numbers 845, 847 and 848 went to Wankie Colliery in Rhodesia, where they became numbers 5 to 7 in reverse order. After they were finally withdrawn in 1982, one of these three was plinthed alongside the main North road at Hwange. Another of the Baldwin-built locomotives, no. 850, is plinthed at Theunissen in the Free State.

Works numbers

The table lists the Class 16DA engine numbers, builders, years built, works numbers and variations in coupled wheel sizes.

Class 16DA 4-6-2
Builders, Works Numbers & Variations

SAR No.	Builder	Year	Works No.	Coupled wheel dia.
843	Baldwin	1929	60820	63"/1600mm
844	Baldwin	1929	60821	60"/1524mm
845	Baldwin	1929	60822	60"/1524mm
846	Baldwin	1929	60823	63"/1600mm
847	Baldwin	1929	60824	60"/1524mm
848	Baldwin	1929	60825	63"/1600mm
849	Baldwin	1929	60826	60"/1524mm
850	Baldwin	1929	60827	60"/1524mm
868	Hohenzollern	1928	4653	63"/1600mm
869	Hohenzollern	1928	4654	63"/1600mm
870	Hohenzollern	1928	4655	60"/1524mm
871	Hohenzollern	1928	4656	60"/1524mm
872	Hohenzollern	1928	4657	60"/1524mm
873	Hohenzollern	1928	4658	63"/1600mm

Illustration

• 870 Bloemfontein 040479.jpg

  Hohenzollern-built no. 870 at the Bloemfontein Loco Depot, 4 April 1979

• Class16DA844.JPG

  Baldwin-built no. 844 at the SANRASM South Site, June 2011

References

Wikimedia Commons has media related to: South African Class 16DA (4-6-2) Hohenzollern or South African Class 16DA (4-6-2) Baldwin